How to print your PCB at 1:1 and check it on paper
A sheet of paper is the cheapest prototype you will ever make. Printed at exactly its real size, the board shows mistakes that are easy to miss on a screen: a connector footprint mirrored, a module that does not fit between two mounting holes, a pin pitch in mils instead of millimetres. Checking takes ten minutes and a few components from the drawer.
1. Export a true-scale PDF
Load the Gerber ZIP or RAR in PCB Tools and open Gerber to PDF. The PDF is always drawn at 1:1 and is vector, so pads keep sharp edges at any zoom. It holds a top view, a bottom view and one page per layer; you can leave only the pages you need. If the board does not fit the chosen paper, the next larger size is used rather than shrinking the drawing.
2. Print at actual size
In the print dialog choose Actual size, 100% or No scaling. Options called Fit to page, Shrink oversized pages or Fit to printable area change the scale by a few percent, which is enough to make a fine-pitch footprint look wrong. Print in black and white for the sharpest result.
3. Check the scale with a ruler
Every page has a scale bar with its length written next to it. Measure it with a ruler or a caliper: if it reads its stated length, the print is exact. If it is a little short or long, look for a scaling option you missed; some printers also have their own scaling setting in the printer preferences.
4. Lay the components on the footprints
Place the real parts on the top view: connectors, relays, modules, displays, crystals, anything with an unusual package. Pins should fall on their pads, the body should not cover other parts and polarised parts should match the silkscreen. For through-hole parts, push the leads through the paper over a piece of foam to check the spacing.
5. Check the mechanical fit
Cut the outline and hold it against the enclosure, front panel or mating board. Mounting holes, connector openings, buttons and LEDs should line up. The same sheet works as a drilling template: tape it to the panel and centre-punch through the holes.
6. Other uses of the 1:1 print
A mirrored, black-and-white print of a copper layer is the artwork for toner transfer or UV exposure when you etch a board at home. Printed layers are also a convenient way to review a design with colleagues and a record of exactly what was sent to fabrication.
When the paper check is done, work through the pre-order Gerber checklist. To check the board in 3D or in a simulation, see using the 3D model for FEM.